1st Gen - For Sale Part Out

Status
Not open for further replies.

harryron

The Grumpiest of Mid-Westerners
Location
ohio
I'm parting out my 2004 xterra.
Buyer pays shipping on parts. I will be adding to it as I find parts and getting pictures of them.
20200501_152041.jpg
Snorkel sold
Center console bezel sold.
 
Last edited:

reaver

Lockers Installed
Supporting Member
Location
Caldwell, ID
I'm parting out my 2004 xterra.
Buyer pays shipping on parts. I will be adding to it as I find parts and getting pictures of them.
View attachment 13957

If you could post a parts list, you might get some more interest. I've managed to aquire most of the mods/items I've been wanting, but depending on what you have, I could pick up a few things that were farther down my list.
 

harryron

The Grumpiest of Mid-Westerners
Location
ohio
If you could post a parts list, you might get some more interest. I've managed to aquire most of the mods/items I've been wanting, but depending on what you have, I could pick up a few things that were farther down my list.
I'll get a list up this weekend. What are you looking for?
 

harryron

The Grumpiest of Mid-Westerners
Location
ohio
Whats wrong with it? And how much for the whole thing?
The snorkel and bezel are sold. It won't start it had a bad misfire when it was running. It needs a new exhaust from the block back (no cats) it is basically running straight pipe this winter has been hard on it. 3 of the 4 windows don't work. The hatch is rusted out and the rear passenger door is getting that way. Oh then there is the issue of the gas tank not venting so it takes about 20 minutes to fill up.
 

Xterrorista

Charcoal Briquette
Supporting Member
Location
Denton, TX
The snorkel and bezel are sold. It won't start it had a bad misfire when it was running. It needs a new exhaust from the block back (no cats) it is basically running straight pipe this winter has been hard on it. 3 of the 4 windows don't work. The hatch is rusted out and the rear passenger door is getting that way. Oh then there is the issue of the gas tank not venting so it takes about 20 minutes to fill up.
Well, it looks sexy at least.
.
 

G34RH34D

Test Drive
Location
Nevada
How are the inner/outer tie rods, control arm bushings (upper/lower) and also the ball joints upper and lower? Even the stabalizer/swaybar end links?
 

harryron

The Grumpiest of Mid-Westerners
Location
ohio
How are the inner/outer tie rods, control arm bushings (upper/lower) and also the ball joints upper and lower? Even the stabalizer/swaybar end links?
I have some HD tie rod I'm going to post when I get to it, would need new ends. Control arm bushings probably need changed, swaybar and links gone.
 
Status
Not open for further replies.
Top