Shrockworx sliders question

akuria

Wheeling
I have a beat on some used shrock sliders for a good price but they are for the 2" BL and I do not have the BL. Can I just drill new holes in them to lower them down to fit or are they no good for me?
 

XTP_Dyer

First Fill-Up (of many)
Location
Nashville
Just have the person send you a picture of the sliders with the mounting plate. If the deal is sweet enough, go either way..you seem pretty handy.
 

Slasa

Lockers Installed
Location
Denver
I don't think there is enough room on the plates to lower them just by drilling new holes. You would have to cut off the mounting arms and re-weld them into position.


Sent from my iPhone using Tapatalk
 

Cruecible

Titan Swapped / SAS'd
Location
Albuquerque, NM
I have a beat on some used shrock sliders for a good price but they are for the 2" BL and I do not have the BL. Can I just drill new holes in them to lower them down to fit or are they no good for me?

Sell them to me if they don't work, add a little extra for your "finder's fee", and bam, you're better off than before lol
 

akuria

Wheeling
I don't think there is enough room on the plates to lower them just by drilling new holes. You would have to cut off the mounting arms and re-weld them into position.


Sent from my iPhone using Tapatalk

Yeah. That's what I was afraid of.


Sent from my iPhone using Tapatalk
 

akuria

Wheeling
I think I'm going to pass on the sliders and order a set of universal ones for $180. Then weld it straight to my frame.


Sent from my iPhone using Tapatalk
 
Top